Saturday, April 6, 2019

Key Points On How To Make Paper Beads

By Matthew Bennett


Turning junk mainly, magazines, calendars and brochures into decors is a very great project. Before throwing away your junk papers, you might consider recycling them into something useful. Below are some steps on how to make paper beads out of your favorite colored pieces of paper.

Step one is to cut triangles out of colored magazines, newspapers or construction papers using a pair of scissors or a craft knife. The triangles should be long. One can use a paper template to guide him or her in the cutting. The width of a bead is usually the base of the triangle. You then draw on each cut-out your design using pens, pencils or markers. Your design should be focused on the outermost edges and the paper tips since they are the only ones which can be visible. You then add a bit of glue to the sharp end.

Secondly, take a strip and roll it onto itself from the wide end using a toothpick or dowel. This forms a cylindrical shape. When you are through with the alignment, roll the piece back and apply some glue across the breadth using a hairbrush. To ensure the symmetry of the bead is achieved, roll the paper over the glue and make sure at each side the spirals are equal. If you want a freestyle design, you should not trouble over alignment and you can then let the strip be a bit off the center.

The third step involves gluing the aforesaid rolled piece of paper on the apex. Caution should be taken to ensure that it stays firmly rolled. Other considerations that you should put in place are to ascertain the paper is glued down. This ensures that the pressure conveyed is effectively absorbed. If the gluing does not work, you should apply once anew till it functions appropriately.

Next, put your bead on a string in the size you require. Apply varnish to seal the outside of your beads using a brush and leave them to dry out. This assists in hardening and making them water resistant. It is wise to twist them around the bamboo skewer so that they do not stick when they are fully dry. Use foam or a cushion to hold up the rolling tube and stop the excess glue from spreading. Numerous coats are added to ensure the finish lasts longer and is glossy.

After the beads are dry and the varnish is well set, remove them from the dowel and place them in strings. Sliding the beads off the cocktail stick is a safe way of removing the beads and ensuring the safety of your work. If some items untie, it shows that the paper was not wrapped or glued well. Think of putting them back to the cocktail stick and add more glue. Leave them to dry for some more hours.

Crafting more beads will complete the project. You can add some paint to bring out your designs and put some glitters on the blobs convey the sparkly form. Tie the beads in a string and not a thread. Make decorating patterns with the string along the outer surface of a paper. For geometric and spiral patterns, use a little wire to align the beads. A little glaze might be added using nail polish or paint for coating.

A keen follow on this procedure gives you fine results as the items are delicate at times. They can also be used to make earrings, necklaces, and bracelets. You can also decorate your house with them. This is considered a good way of conserving the environment.




About the Author:



No comments:

Post a Comment